Thread: Post here please your help request regarding Garmin

Originally Posted by Karma67

Well i have updated to v5..dl Uk map from here and got id for them.. put in SW and GMAPSUPP and then into Garmin file...turned on GArmin on my phone...starts up....and......


STILL no GPS or Maps :7ej:

I when and d/l gpsgate...rich version as suggested in keygen notes..and even that cant find my gps!!!! arghhhhhhhhhhhhhhhhhh!!!


HELP!!! PLEASEEEEE!!!!!!!

If garmin doesnt recognize internal gps it can be just the .txt file issue, control with xplore , not in windows.

Originally Posted by Karma67

Thanks for the reply catymag....thats was where i started off..and have read it many times!! lol

would my phone device showing up as an F drive instead of an E make a difference....?? I dont think so but im grasping at straws now lol

I think you are speaking about letter drive your pc shows and it can be E or F or G,that's depends on devices you have attached to your pc.
My post spoke about the letter E that symbian os assigns to your mc card in your phone os

I explain drive letters in S60 :
C:\. This drive is also called phone memory. Basically it is a flash memory where we can install applications and store our data. Unlike memory card, it is always inside our phone. So, even if we remove the memory card, our data are still there. However, note that the size of phone memory is limited.
D:\. It is the drive used to store temporary files. The contents will be deleted when the device reboots. In many cases, we don’t use this drive.
E:\. It is the drive of your memory card. Normally, this is the place where we install applications and install our data.
Z:\. This is where the ROM image is stored. It contains all the operating system’s applications and data files. Since it is read-only memory, you cannot write anything. The only way to modify the contents of Z:\ drive is by flashing the phone, for example via Nokia Software Updater

Originally Posted by terente

To be more specific, the restart happens when I try to go on the map to the newly created point (I changed only the name of an old point).

You are right, probably it's a bug of this version