GO930 connection issue

**maa1506** · 14th April 2020, 06:00 PM

I have dug out my old Go930 to update it. Have downloaded the latest version of TT Home however when I connect the nav to my PC it is not showing up anywhere. TT Home says device not connected and it does not show up as a connected deice anywhere in Windows. PC operating system is Windows 10 X64 ver 1909. Any ideas please?

**biggerdave** · 14th April 2020, 06:13 PM

Maybe try an alternative USB port if you have one? (I'm guessing it has been charged for a couple of hours first?)
Does it start up OK with the black dos-like screen first then normal menus etc? Try holding the power button in until you see that dos screen THEN release the button.

**maa1506** · 15th April 2020, 06:10 PM

Thanks for the reply. Left on charge for a few hours. Tried different ports and a different cable. Tried doing the reset thing. If I hold down the power button for a few seconds, it does show the black screen, but then does not progress any further. If i just press the power button normally it starts up fine. Another thing is when I put a blank formated SD card into the unit, it does not write the ttgo.bif file to it. If I put the card in with the new map on it, the map is listed so it obviously must be recognising the card is there. However without the ttgo.bif file I can't get fast activate to work

**biggerdave** · 15th April 2020, 06:21 PM

Try to just copy the ttgo.bif from internal onto the card then you should be able to activate it.

**maa1506** · 15th April 2020, 06:44 PM

Originally Posted by biggerdave

Try to just copy the ttgo.bif from internal onto the card then you should be able to activate it.

Is there a way of doing that the nav unit itself as it wont show up in on the computer?
The nav unot already has a patched navcore on it. If I did a factory reset would that make a difference or would it revert back to the original tt system?